Concrete Spalling

Concrete spalling is often caused by improperly placing the rebar or wire mesh when pouring the concrete. If the rebar is to close to the top of the concrete slab, as water soaks into the concrete it will start to corrode the rebar. This will cause the rebar to expand, weakening the concrete above the piece of rebar.

Concrete Spalling

Concrete Spalling

If you look left of the blue line, you will notice there is a crack starting to form, this crack is right above a piece of rebar corroding. When we tap the concrete with a hammer we hear a hollow sound. To repair this we have to break out all the loose concrete, cut 90 degree edges, pressure wash & clean the rebar, and apply a non-shrink repair mortar.

Spalling Concrete Cause By Corroding Rebar

Spalling Concrete Cause By Corroding Rebar

Right after we start to chip out the bad concrete a piece of rebar started to stick out. This was the main cause of the damaged concrete. It is very important to place rebar and wire mesh at the proper place when pouring concrete.

Spalled Concrete Area Chiseled Out

Spalled Concrete Area Chiseled Out

Concrete Resurfaced & Stained

Concrete Resurfaced & Stained

After the concrete was chiseled out we applied Miracote RM 2 and then finished of the spalled concrete repair by resurfacing the area with Miracote MPC, and then applied a grey stain to match the bricks.

Leave a Reply